The global batching interval (minutes) is the only control one has over
outbound batching. There are no other triggers, settings, apis, etc.
The
batching interval value is stored in esp.ini. The HIPAA service queries
this file every 30 seconds.
<ndillon45@[EMAIL PROTECTED]
> wrote in message
news:1184953419.429449.97080@[EMAIL PROTECTED]
> Our requirement is to create a single 834 eligibility file with
> multiple ST/SE segments grouped by a particular field within our
> query, i.e. "account_id". This solution works just fine:
>
> 1. Use Multiple Schema
> 2. Use XPath to loop thru each group of "account_id"s
> 2a. Create message to send to HIPAA ****t for each account_id group
> 3. Turn batching on, set batching interval to 50 minutes.
>
> Since all of these accounts can be generated in under 50 minutes, this
> works fine. However, we have other processes that use the HIPAA
> Accelerator and the 50 minute batch interval is slowing these
> processes down since they would normally only take a few minutes to
> generate.
>
> So, my question: Is there any way to force the HIPAA accelerator to
> batch based off a variable or some other trigger? This would allow us
> to batch whenever we determine all messages that need to be in the
> batch have been sent, thus reducing the time from the last message
> sent to the next batch interval.
>
> Any ideas?
>
> Thanks!
>
|
