I created the two send ****ts necessary for the party to send HIPAA files,
but
I don't get a 997 when I process an 837 through the same parties receive
locations. I was also looking at the HIPAA Re****ts through HAT and it
never
shows that I have recieved anything eventhough it just processed the 837
file. I saw another thread about are you using the HIPAA pipeline
component
and we are. We have created a custom HIPAA pipeline that has the HIPAA
pipeline componenet. Does this have anything to do with our issue?
"Eric Stott" wrote:
> HIPAA_EDI, all of their do***ents will be routed. There does not need to
be
> any subscription, the 997 actually never comes into BizTalk, the HIPAA
> service just looks at the management database to find out where it needs
to
> send the ACK, since you can only have one party defined in a HIPAA send
****t
> (one for each party), the service just runs and finds out where that
party's
> data goes and creates the 997 and places it where you have specified it
in
> the adapter properties.
>
> Hope that this helps,
> Eric
> http://blog.biztalk-info.com
>
> "DavidReck" <DavidReck@[EMAIL PROTECTED]
> wrote in message
> news:1A3DBA7A-77B6-4FE3-8FED-9974A5F67D61@[EMAIL PROTECTED]
> > What is the subscription on the send ****t? What adapter am I suppose
to
> > use
> > on the ****t?
> >
> > "Eric Stott" wrote:
> >
> >> Yes, you will need to set up a send ****t for that outbound 997.
> >>
> >> Eric
> >> http://blog.biztalk-info.com
> >>
> >> "DavidReck" <DavidReck@[EMAIL PROTECTED]
> wrote in message
> >> news:3B40FE29-7938-4732-800D-930DCEA83AE4@[EMAIL PROTECTED]
> >> > We are using BizTalk 2004 and the HIPAA Accelerator 3.0
> >> >
> >> > I am trying to enable the generation of a 997, functional
> >> > acknowledgement
> >> > on
> >> > a recieve location. In the HIPAA EDI Trans****t properties I have
set
> >> > the
> >> > functional acknowledgement to always, but I do not know what else I
> >> > need
> >> > to
> >> > do. We are able to process the incoming 837 files fine, but no 997
> >> > file
> >> > is
> >> > generated from the incoming file. Do I need to create a send ****t
for
> >> > the
> >> > 997 to go out on? If so what is the adapter I am suppose to use
and
> >> > are
> >> > there any other special settings? I have not been able to find any
> >> > do***entation on enabling the 997 other then setting the flag to
> >> > always.
> >> > I
> >> > have also deployed the 997 schema to my server because I saw an
issue
> >> > on
> >> > microsoft about the schema not being deployed. Thanks for the
help.
> >> >
> >> > David
> >>
> >>
> >>
>
>
>
|
